Basic Service - Martin Acrobat User Manual

B
ASIC SERVICE
To set the 6/7-ch. DMX jumper
1 Disconnect the fixture from power.
2 Remove the effects section cover. It is secured by 5 Torx-20 screws: 3 on the
side with print and 2 on the other side.
3 Locate PL 118 on the printed circuit board, next to DIP-switch pin 12.
4 Using a pair of tweezers or similar tool, place the jumper on 1 of the 2 pins, or
remove it completely, for 6-channel DMX operation. Place the jumper on both
pins to enable 7-channel DMX operation.
5 Replace the cover before applying power.
To replace the main fuse
1 Unplug the mains cable from the input socket. Pry open the fuse holder and
remove the fuse.
2 Replace the fuse with one of the same type. The fuse rating is listed on serial
number label.
18

Basic service

9
Acrobat user manual