uuIndicatorsu
Indicator
Name
System Message
Indicator
Turn Signal and
Hazard Warning
Indicators
High Beam
Indicator
Auto High-beam
System Indicator
Lights On
Indicator
*1:Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
* Not available on all models
90
On/Blinking
Comes on for a few seconds when
●
you turn the ignition switch to ON
*1
, then goes off.
(
w
Comes on along with a beep
●
when a problem is detected. A
system message on the driver
*
information interface appears at
the same time.
Blink when you operate the turn
●
signal lever.
Blinks along with all turn signals
●
when you press the hazard
warning button.
Comes on when the high beam
●
headlights are on.
Comes on when all the operating
●
conditions of the Auto high-beam
*
system are met.
Comes on whenever the light
●
switch is on, or in AUTO
the exterior lights are on.
Explanation
While the indicator is on, press the
●
(display/information) button to see the
message again.
Refer to the Indicators information in this
●
chapter when a system message appears
on the driver information interface. Take
the appropriate action for the message.
The driver information interface does not
●
return to the normal screen unless the
warning is canceled, or the
is pressed.
Does not blink or blinks rapidly
●
2 Replacing Light Bulbs P. 574
2 Auto High-Beam System
If you remove the key from the ignition
●
switch
*1
while the exterior lights are on, a
*
when
chime sounds when the driver's door is
opened.
Message
button
—
*
P. 181
*
—
—
—
—
—