■
To manually cancel the system temporarily
You can cancel the operation when you manually change the headlights to high
beams. Push the lever forward until you hear a click, or lightly pull the lever towards
you to flash high beams. The auto high-beam system indicator goes off.
If you want the auto high-beam system operation to resume at once, pull the lever
towards you.
■
To Disable the System
uuOperating the Switches Around the Steering WheeluAuto High-Beam System
Disable the system when the vehicle is parked
with the power mode in ON and the light
switch is in the AUTO position.
To disable the system: Pull the light switch
lever towards you and hold it for 40 seconds.
The auto high-beam indicator in the meter will
blink twice.
To enable the system: Pull the light switch
lever towards you and hold it for 30 seconds.
The auto high-beam indicator in the meter will
blink once.
1To Operate the System
If the
message appears:
•
Park your vehicle in a safe place, and clean the
windshield. If the message does not disappear after
you have cleaned the windshield and driven for a
while, have your vehicle checked by a dealer.
1To Disable the System
The auto high-beam system will remain in the
selected disabled or enabled setting each time you
start the engine.
*
183