Parts; Replacement Parts - Jet J-9225 Operating Instructions And Parts Manua

Troubleshooting (cont.)
Fault
1. Blade speed too high for feed
Bad cuts (rough)
2. Blade is too coarse.
1. Blade is binding in the cut.
Blade is twisting
2. Blade tension too high
1. Blade guides worn
2. Blade guide bearings not adjusted.
Unusual wear on
side/back of blade
3. Blade guide bearing bracket is

Parts

Replacement Parts

Replacement parts are listed on the following pages. To order parts or reach our service department, call
1-800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and
Serial Number of your machine available when you call will allow us to serve you quickly and accurately.
Probable Cause
pressure.
loose.
1. Reduce blade
pressure.
2. Replace with finer blade.
1. Decrease feed pressure.
2. Decrease tension on Blade
1. Replace blade guides.
2. Adjust blade guide bearings.
3. Tighten blade guide bearing bracket.
18
Suggested remedy
speed and feed