Connecting An Av Receiver - Sony KP-51WS510 Service Manual

Installing and Connecting the Projection TV

Connecting an AV Receiver

z
You can connect an
AV receiver using both
composite video and S
VIDEO. If both are
connected, then the TV
will detect and display an
S VIDEO signal. To take
advantage of this feature,
connect your receiver
with Video 1.
Rear of projection TV
S VIDEO VIDEO
30
For greater control of all audio and video equipment, connect an AV receiver.
✍
Change "Video Label" for the VIDEO 1 input to "Receiver" (see page 62).
Disconnect all power sources before making any connections.
1
Connect the coaxial cable from the incoming cable connection or
antenna to IN on the VCR.
2
Using a coaxial cable, connect OUT on the VCR to VHF/UHF on the
projection TV.
3
Using a VIDEO cable, connect VIDEO of VIDEO 1 IN on the
projection TV to MONITOR OUT on the AV receiver.
4
Using an AUDIO/VIDEO cable, connect TV OUT on the projection TV
to AUDIO/VIDEO 2 IN on the AV receiver.
5
Using an AUDIO/VIDEO cable, connect the video equipment to the AV
receiver.
6
Select the Setup menu and set "Video Label" to "Receiver" to fix your
TV's input to AV receiver (see "Video Label" on page 62).
AUDIO-L
VIDEO
AUDIO-R
VMC-810S/820S (not supplied)
VMC-10HG (not supplied)
Optional S VIDEO cable
YC-15V/30V (not supplied)
Coaxial cable (not supplied)
VMC-810S/820S
(not supplied)
AUDIO/
VIDEO 2 IN
MONITOR
OUT
AV receiver
VMC-810S/820S
(not supplied)
VCR
Cable/
Antenna
AUDIO/
VIDEO 1 IN
AUDIO/VIDEO 1 OUT