Device number
Connector
System fan 1
J6 on the AC power board
System fan 2
J8 on the AC power board
System fan 3
J10 on the AC power board
System fan 4
J11 on the AC power board
RJ45 cable
J1 on the AC power board
connector
UID cable
J12 on the AC power board
connector
A new system fan can be installed to allow the server to operate properly in case a default system fan
becomes defective.
To remove the system fan:
1.
Disconnect the fan cable from its corresponding board connector.
2.
Lift the system fan away from the chassis.
Figure 35 Removing the system fan
Contents 50