Operation - DeWalt DWV009 Instruction Manual

WARNING: The filter (I) must always
be in place and tightened properly while
vacuuming, except as described under
Wet Pick Up Applications under
Operation. Otherwise, hazardous dust
could come through the unit. When
vacuuming fine dust, you may also use
an additional paper bag or fleece bag to
make emptying the canister easier.
1. If optional paper or fleece bag (M) is to be used, install as shown
in Figure 3.
NOTE: Be careful not to tear the bag. Place bag securely onto
the backside of the inlet (J) to provide a tight seal for maximum
dust collection performance.
FIG. 3
M
J
2. Place the vacuum head (C) onto the canister and secure it by
closing the canister latches (D).
3. Insert end of hose (G) into hose inlet (J) and rotate clockwise to
lock in place.
Page dimensions: 5.8 x 8.3 inches Page dimensions: 5.8 x 8.3 inches
FIG. 2
I
FIG. 4
J
G
27

OPERATION

WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories. An accidental start-up can cause injury.
1. Plug the power cord into an
appropriate outlet.
2. Turn on the main on/off power
switch (E).
CONNECTING TO POWER
TOOLS (FIG. 1, 6)
1. Plug the vacuum power cord into an appropriate outlet.
2. Plug the power tool into the outlet (L) and make sure the power
tool is properly grounded.
FIG. 6
N
Q
3. Choose the correct power tool adaptor (P) to fit the power tool
connection on the tool to be used, refer to Accessories under
Maintenance. Attach power tool adaptor (P) to power tool.
FIG. 5
E
P
Q