Operation - DeWalt DWV112 Instruction Manual

ENGLISH
Accessory Bag Holder Assembly (Fig. D)
Place the accessory bag holder into the hole of bracket. (See
illustration).
Fig. D

WARNING: To reduce the risk of fire or explosion, do
not operate this vac in areas with flammable gases,
vapors or explosive dust in the air. Flammable gases
or vapors include but are not limited to: lighter fluid,
solvent-type cleaners, oil-based paints, gasoline,
alcohol or aerosol sprays. Explosive dusts include
but are not limited to: coal, magnesium, aluminum,
and grain or gun powder. Do not vacuum explosive
dust, flammable or combustible liquids or hot ashes.
Do not use this vac as a sprayer for any flammable
or combustible liquid. To reduce the risk of health
hazards from vapors or dusts, do not vacuum toxic
materials.

WARNING: The operation of any utility vac can result
in foreign objects being blown into the eyes, which
can result in severe eye injury. Always wear safety
goggles complying with ANSI Z87.1 (or in Canada,
CSA Z94.3) before starting operation.

CAUTION: To reduce risk of hearing loss, wear ear
protectors when using the vac for extended hours or
when using it in a noisy area. The unit is ready for dry
vacuuming or blowing. After you plug the power cord
into the wall receptacle, turn the unit "ON" by pushing
the switch position with 1 embossing straps is the
"ON" position.
Fig. E
ON

OPERATION


WARNING: Always observe the safety instructions
and applicable regulations.

WARNING: To reduce the risk of serious
personal injury, turn unit off before making any
adjustments or removing/installing attachments
or accessories. An accidental start-up can
cause injury.
22
OFF ON
Dry Pick-Up
1. The filter must always be in correct position to reduce
the risk of leaks and possible damage to vac. Make sure
that the filter is completely covering the filter cage.
Make sure there are no gaps between the filter and
the lid. It is very important to assemble the filter to the
cage without allowing any possible leaks or tears. Any
leaks will allow the picked up debris to be blown out
of the blowing port and back into the surrounding
environment.
2. When using your vac to pick up very fine dust, it will be
necessary to empty the dust tank and clean or replace
the filter at more frequent intervals to maintain peak vac
performance.
Note: A dry filter is necessary to pick up dry material. If you
use your vac to pick up dust when the filter is wet, the filter
will clog quickly and be very difficult to clean. If the filter
gets wet, replace it before continuing to do dry pickups.
Installing the Cartridge Filter (Fig. F)
The cartridge filter can be used for wet or dry pick,
installation is the same for both.
1. With the power head in an upside down position, slide
the cartridge filter down over the lid cage, push the filter
seals against the power head.
2. Turn the knob on filter retainer clockwise to tighten,
locking the filter into place.
3. To remove the filter for cleaning, turn the filter knob
counter clockwise till feel the tactile and auditory cue,
and make sure the knob arrow align with the "Unlock"
icon on the filter cap, then slide the cartridge filter off
the lid cage.
4. To clean the cartridge filter, shake or brush off excess
dirt or rinse (from the inside of the filter) with water, dry
completely (approximately 24 hours) and re-install.
Fig. F
Note: If the filter has been used for wet pick-up, it must be
cleaned and dried before using for dry pick-up.
Installing the Disposable Filter Bag (Fig. G)
OFF
1. Slide the cardboard collar opening firmly onto the vacuum
port deflector until it stops against the deflector wall.
2. Position the bag so that it is distributed around the
inside of the tank.
3. Replace and secure the power head onto the tank.
Lock