Using Your Remote Control; Selecting A Device; Using Touch Screen Keys And Hard Keys; Selecting Extra Functions - Philips SRU9600 Instructions For Use Manual

4
2
Turn the rotary wheel clockwise or
anticlockwise to select your preferred language.
3
Press the OK key to confirm the selected
language.
The SRU9600 will guide you through the setup
process via questions in the upper part of the
display.
4
Follow the instructions on the remote control.
Replacing Batteries
When the batteries are almost empty, the Battery
Low icon
critical battery level.
Note If the Battery Low icon is blinking, you can still
operate the remote control, however you will no
longer be able to enter the Setup menu.
1
Press the battery cover at the back of the
remote control inwards and slide it in the
direction of the arrow.
2
Place the three L06 or AA type alkaline
batteries back into the battery compartment, as
shown.
3
Slide the cover back on and click it firmly into
place.
Please follow the local regulations for disposal of
the empty batteries.

Using Your Remote Control

Selecting a Device

You select the different devices you have installed on your remote control
by turning the rotary wheel clockwise or anticlockwise. The moment you
stop rotating, the touch screen and the hard keys keys work for that
selected device.

Using Touch Screen Keys and Hard Keys

The most frequently used functions of your devices are covered by the
touch screen keys and hard keys. On the touch screen you only see the
functions that are applicable for the selected device. Press the Page 2 key at
the bottom of the touch screen for more functions.

Selecting Extra Functions

Devices can also have extra functions, that are not covered by the touch
screen keys or the hard keys on the SRU9600. You can select these extra
functions in the upper part of the display.
1
Press
The touch screen keys disappear and extra
functions for the selected device appear in the
upper part of the display.
2
Turn the rotary wheel to scroll through all extra functions.
3
If you have selected the function you were looking for, press
The remote control sends out the IR signal and returns to the touch screen
keys of the selected device.
For adding extra functions, see chapter "Add a Function" on page 6.
Tip If you cannot find the extra function you are looking for, you can exit the Jog
Mode by pressing
will start blinking, indicating the
.
again.
.