Use Your Universal Remote Control; Learning - Philips SRP2018 User Manual

3 Use your
universal
remote control

Learning

You must have an original remote for the
Universal Remote Control (URC) to learn code
from it.
Learn commands
1
Press and hold the device selection button
(e.g. TV) for 5 seconds until the red LED
is on.
2
Enter the learning code
red LED will flash once and then remain
on.
3
Place the universal remote control and the
remote control of your device on a flat
surface, aiming at each other at a distance
of 3 to 5 cm apart.
4
Press and release the desired key on the
universal remote control which you want
the command to be learned. The LED
indicator will flash twice then remains on.
5
Press and hold the target key on the
remote control of your device for a few
seconds.
6
If the LED indicator light flashes once and
then remains on, the command has been
learned successfully. You can release the
key on the remote control of your device.
If the LED indicator light flashes six times
quickly, it means there's an error in the
learning process. Adjust the position of
both remote controls and repeat from
Step 4 again.
6 EN
9 9 9 0 0
. The
7
Repeat from step 3 to learn other key
functions, or press and hold any key for 3
secouds to terminate the learning mode,
the LED indicator will go out immediately.
Note
•
On Step 4, if no key is selected for more than 15
seconds, the LED indicator will flash six times and the
learning mode will exit automatically.
•
On Step 5, if no other remote signal is received for
more than 30 seconds, the LED indicator will flash
six times and then remains on. You will need to select
a desired key again for learning as in Step 4 on your
universal remote control.
•
Each function key will hold only one command, a new
command to be learned will automatically replace the
previous one.
Clear learned commands
Clear all codes learned for a particular device
1
Press and hold the device selection button
(e.g.TV) for 5 seconds until the red LED
light is on.
2
Enter the learning code
The red LED light will flash once and then
turns off.
» All codes learned for the device will be
cleared.
Clear all codes learned for the universal
remote control
1
Press and hold the device selection button
(e.g.TV) for 5 seconds until the red LED
light is on.
2
Enter the learning code
red LED light will remain on briefly, flash
twice and then turns off.
» All codes learned for the universal
remote control will be cleared.
9 9 9 1 0
.
9 9 9 1 0
. The