Test Mode; Master Volume - Onkyo HT-R820THX Service Manual

OPERATION CHECK-2
CURRENT DETECTION PROTECTORS
<Note1>
In test mode " Test 4-32 ", the pulse waveform is outputted from DSP IC on the pre-amplifier section, and it is inputted into
a power amplifier circuit. Refer to <Fig-1>.
Therefore an external input is unnecessary in check.
<Note2>
Don't connect speakers or any load.
Don't short speaker terminals.
Don't check two or more channels simultaneously.
1. Set the unit to test mode " Test-4-00 " .
1-1. Press and the hold down the CD button , then press the STANDBY/ON button when the unit is Power On.
T e s t - _
1-2. Press the VIDEO 3 button, while the " Test - _ " is shown.
Unit will be in the state of " Test-4-00 ".
T e s t - 4 - 0 0
2. Repeat and press SPEAKERS B to the " Test-4-32 " is shown.
T e s t - 4 - 3 2
3. Connect the road resistor 3 ohms to the speaker terminal.
4. Check that the " P rot ec t " is not shown.
5. Connect the road resistor 1.5 ohms to the speaker terminal.
6. Check that the " Protec t " is shown, and speaker relays are turn off.
P r o te c t
7. Check about the FL, FR, C, SL, SR and SB channel one by one.
8. Press the STANDBY/ON to power Off. (Exit the test mode)
<Fig-1>
The output waveform from DSP IC in the test mode 4-32.
2 ms 2 ms
20 ms
blinks
Details of TEST MODE 4-32

TEST MODE

4-32

MASTER VOLUME = 54

DSP DSP
output voltage
output ch.
Max.
ALL
HT-R820THX