LG GR-B197GVQ Service Manual page 19

Install Water Filter (Applicable to
some
models)
Before
Installing water
filter
1. Before
installing
the
filter,
take
out
the
top
shelf of the
refrigerator
after
tilting
it
to
the direction and
lifting
it
to
the direction and
move
it
to
the lower
part.
2. Remove the
lamp
cover
by pressing
the
protrusion
under the
cover
and
pulling
the
cover
to
the front.
Installing water filter
1. Initial installation of
water
filter
Remove the filter substitute cap
by turning
it
counterclockwise by 90 degrees and pulling it down.
Note
:
Keep
it
handy to
use
it later when you do
not
use
the filter.
Remove the red cap from the filter and attach the
sticker. Insert the upper
part
of the filter after
aligning
with the
guideline
marked
on
the control box, and fasten
it by turning it clockwise by 90 degrees.
Note
:
Check that the
guideline
and the
fastening
indication line
are
aligned.
2.
Replacement
of water filter
While holding the lower
part
of the filter, turn it
counterclockwise
by 90 degrees
and
pull
it down.
Note
:
Check that the
guideline
and the
loosening
indication line
are
aligned.
After
installing water
filter
Reassemble the lamp
cover
and the
top
shelf of the
refrigerator.
To
place
the
top
shelf of the
refrigerator,
raise
the front
part
of the shelf
a
bit
so
that the hook of the shelf
is fit into the groove.
In order to clean the water filter
system,
drain water for
about 3 min.
Note
:
Then open the door of the
refrigerator
and check for
water drops
on
the shelf under the filter.
HOW TO INSTALL REFRIGERATOR
-19-
Control box
Aligning with the guide line
and the
fastening
indication line
Control box
Aligning with the guide line
and the
loosening
indication line
Removal
of red cap
Sticker
Substitute
cap