Bose Lifestyle 650 Owner's Manual page 31

Symptom
The wireless receiver
status LEDs are solid
amber (dim)
Sound is distorted
No sound from a
connected device
No TV picture, but audio
is heard
A connected device
is not responding
consistently to remote
commands
Intermittent audio
dropouts heard on
coaxial digital audio
devices
Connecting to a new
network or different
network
Solution
• Follow the on-screen troubleshooting prompts.
• Press the
®
rerun the UNIFY
• Unplug the power cords for the receivers, wait 30 seconds and
plug them firmly into a live AC (mains) outlet.
• Make a wired connection to your rear speakers. Contact Bose®
customer service. Refer to the contact sheet in the carton.
• Cycle through and test different sources.
• Reduce the volume output level from any devices connected to the
control console.
• Make sure the audio input cable from your source device is
connected and not damaged.
• If you have not previously run ADAPTiQ®, select ADAPTiQ® from
®
the UNIFY menu (see page 13).
• Unplug the power cord for the console, wait 30 seconds and plug it
firmly into a live AC (mains) outlet.
• Power on the device.
• Cycle through and test different sources.
• Refer to the device owner's manual.
Make sure the TV video input selection is correct for the video source.
• Try setting up the device again. Press the
control console. Select the device options and follow the on-screen
instructions to set up the device again.
• Replace your remote's batteries (see page 42).
• Set up your IR emitter (see page 32).
• Confirm that the audio cable is properly connected to the console
and the coaxial digital audio device.
• Cycle through and test different sources.
• Try setting up the device again. Press the
control console. Select the coaxial digital audio device options and
follow the on-screen instructions to set up the device again.
• Unplug the power cord for the console, wait 30 seconds and plug it
firmly into a live AC (mains) outlet.
• If your network information has changed or to connect your system
to another network, refer to the SoundTouch® in-app help.
• If having problems connecting wirelessly, connect to the network
using an Ethernet cable.
T R O U B L E S H O O T I N G
button on the control console or your remote and
setup (see page 14).
button on the
button on the
E N G L I S H - 3 1