Explicit Call Transfer - Philips 330 Owner's Manual

end the conference with
disconnected. In order to make consecutive outgoing
calls, first initiate a normal call with the first number of
the conference. When the first member is on line, ini-
tiate a second call as described in "Make a second call"
above. When the second call is engaged, press
select Conference. Repeat the above process until five
members are connected.
If there is an incoming call during the conference call,
and if there is less than five members, you can accept
this new call by pressing
then select to add this member to the con-
Conference
ference call. If there is an incoming call during a con-
ference with five members already connected, you can
answer this new incoming call, but not add it to the
conference. While a conference call is in progress, press
,
to access the Conf. members
a member of the conference by selecting
,
and pressing to confirm, or select
have a private call with this member only (other mem-
bers are put on hold)
68
)
. At this point all calls are
,
, ,
. Press again and
options. Disconnect
Remove party
Private call

Explicit Call Transfer

Subscription dependent
You can connect an active call and a call on hold. You
are disconnected when the transfer is completed.
and
During a call press
This feature is different from the Call forward, which
takes place before you pick up the call (see page 32).
to
,
, select and press
Transfer
Other operator services
,
.