Conference Call (Subscription Dependent); Explicit Call Transfer (Subscription Dependent); In-Call Symbols - Philips Xenium User Manual

Conference Call
The user can activate the conference call by making consecutive outgoing calls, or create it
from a multiparty call context. The user may have up to five members at the same time. He can
end the conference with
When making consecutive outgoing calls, first initiate a normal call with the first number of the
conference. Then when the first member is on line, initiate a second call as described in making
a second call paragraph page 53.
When the second call is engaged, press the Pilot Key and select
process up to five members.
If there is an incoming call during the conference call, and if there is less than the five members,
you can, by pressing the Pilot Key, accept the second call as described in paragraph "answering
a second call" page 53, or, by pressing the Pilot Key and then selecting
this member to the conference call.
If there is an incoming call during a conference with five members already connected, you can
answer this new incoming call, but not add it to the conference.
Explicit Call Transfer
dependent)
You can connect an active call and a call on hold. You are disconnected when the transfer is
complete. During a call press the Pilot Key
the Pilot Key .

In-call symbols

During calls, you have the following symbols:
. At this point all calls are disconnected.
Mute
Call underway
Active call placed on
hold
Incoming call
Outgoing call
Use of network services
(Subscription dependent)
(Subscription
Transfer
, select
.
Repeat the above
Conference
, you can add
Conference
and confirm by pressing
55