Setup; Set Temperature Unit And Mtc Value; Selecting A Predefined Buffer Group - OHAUS starter 3100 Instruction Manual

EN 8
-
3

SETUP

3.1

Set temperature unit and MTC value

Please note:
If a temperature electrode is used, Automatic Temperature Compensation (ATC) and the sample
temperature are displayed on the screen. You may then choose to skip MTC setup (below).
If the meter does not detect a temperature electrode or one is not used, the meter automatically
switches to Manual Temperature Compensation (MTC) mode and MTC appears on the screen.
MTC can be set as follows:

Power the meter on by pressing

Press and hold
temperature unit blinks (°C or °F).

Press or

Press
Then

Continue with MTC temperature setting by using
compensation accordingly

Press

Press
The default MTC temperature value setting is 25° C (77° F).
Note: ° C = 5/9 (° F - 32)
3.2

Selecting a predefined buffer group

After confirming the MTC compensation temperature value, make the buffer group selection. Use
or to select a buffer group among 3 buffer groups (4.1.1). Press
confirm the setting or press
The default buffer group is b1.
b1 1.68
until the setup icon
to switch between ° C and ° F.
to confirm your selection.
to confirm the setting
to return to the measurement screen.
to leave to return to the measurement screen.
4.01 7.00
STARTER 3100 Bench pH Meter
.
appears on the display and the current
10.01
or to adjust temperature
to