Description of functions
Time Zone Offset
•
•
•
•
Æ page 37
Upload Configuration
•
•
•
Æ page 60
Upload/Download Status
•
Virtual LAN ID
•
•
Æ page 24
VLAN Discovery Mode
•
•
Æ page 24
Make an entry here only if an Æ SNTP server provides time zone infor-
mation.
The specification describes the shift in hours corresponding to the time
zone information of the SNTP server.
Standard value Æ page 95.
Integer editor in optiPoint 410 Æ page 94.
Æ page 60
Use this function to load (back up) an optiPoint 410 configuration on the
Æ FTP server.
The following parameters must be set before the upload operation:
– Æ Download Server Address, Æ FTP Path, Æ Configuration Filena-
me
– Æ FTP account Name
– Æ FTP Username, Æ FTP Password
Quick entry into the optiPoint 410 Æ page 103.
"File Transfer Status" Æ page 71
Can be defined only if the Æ Layer 2 support is activated (Æ QoS L2/
L3).
Enter a value from 0 to 4095 here. This value describes the association
with a certain VLAN, if a Æ VLAN is used.
Æ page 16
Can be defined only if the Æ Layer 2 support is activated (Æ QoS L2/
L3).
Here you must define the location from where the Æ Virtual LAN ID
should be fetched, if Æ VLAN is used.
The ID entered in Æ Virtual LAN ID is used.
Manual
If a Æ DHCP server is used, then the ID delivered by
DHCP
this server is applied.
Æ page 16
Æ page 59
Æ page 59
Alphabetical Reference
81