Cleaning Techniques; End Of Cleaning Operation - Excell EPW2123100 Operation Manual

CLEANING TECHNIQUES

• SAVE ALL INSTRUCTIONS
When cleaning with the pressure washer,
many cleaning tasks can be solved with water
alone, but for most tasks it is advantageous to
use a detergent also. A detergent ensures a
quick soaking of the dirt allowing the high
pressure water to penetrate and remove the
dirt more effectively.
Pressure washer chemicals are specially for-
mulated to be used with your pressure washer.
APPLICATION OF SOAP OR
DEGREASER
1. Apply the solution to a DRY work surface.
On a vertical surface, apply horizontally
from side to side starting from the bottom
to avoid streaking.
NOTE: Wetting the surface first is not
recommended, as it dilutes the
detergent and reduces its cleaning
ability. Avoid working on hot surfaces
or in direct sunlight to minimize the
chances of the chemical damaging
painted surfaces. Damage may occur
to painted surface if chemical is
allowed to dry on the surface. Hold
nozzle far enough away from surface
to prevent damage to the surface.

END OF CLEANING OPERATION

• SAVE ALL INSTRUCTIONS
When you have completed use of the chemical
injection system, remove tube from container.
Continue to run in low pressure position and
inject clean water through the tube and
injection system by placing end of tube in a
container of clean water. Continue to run until it
is thoroughly cleaned.
Copyright © 2017 MAT Industries, LLC
2. Allow chemical to remain on the surface
for a short time before rinsing.
3. Rinse with clean water under high pressure.
On a vertical surface, first rinse from the
bottom up, then rinse from the top down.
Hold nozzle 6 to 8 inches from the work
surface at a 45° angle using the flat spray
as a peeling tool rather than a scrub brush.
APPLICATION OF WAX
1. Immediately after cleaning, apply pressure
washer wax. Place injection tube in
container of wax.
2. Apply the wax sparingly in an even layer.
Apply to wet surfaces from the bottom up
for even distribution and to avoid streaking.
3. Remove the suction tube from the wax
bottle and rinse off the surplus wax.
NOTE: IF SURPLUS WAX IS NOT
REMOVED, A HAZY FINISH MAY RESULT.
4. Wipe dry to reduce water spotting.
12 - ENG