Avaya 3524gt Troubleshooting Manual page 38

Emergency recovery trees
Test 221
Test 271
If an error is found, the test reports FAILED and an error message is displayed and stored in
the Error Log. The Error Log may contain up to 10 POST (or Burn-In) errors. Use the 'e' —
show errors command in the Press menu or the Manufacturing SHOWLOG command to
display errors. Clear errors using the INITLOG command.
If you type CTRL-C on the console during the power-up or reset sequence, the Diagnostics
display the following break message:
>>Break Recognized - Wait . .
After Diagnostics finish initializing, the "Press" menu is displayed:
Press 'a'
Press 'd'
Press 'e'
Press 'i'
Press 'p'
Press 'r'
If you press . . .
a
d
e
i
p
r
38 Troubleshooting
PHYs Register
Ports Internal Loopback
to run Agent Code
to download agent/diag/bootloader code
to display Errors
to initialize config flash
to run POST tests
to reset the box.
Diagnostics executes the Agent code (if present):
Starting Agent Version:
Decompressing the image
Initializing . . . .
The following information is required:
Enter Port Number
Enter Speed: 10, 100 or 1G
Enter Local IP Address
Enter Server IP Address
Enter Subnet Mask
Enter Filename:
The POST test errors are re-displayed:
System Resets
Burn-In Loops
Burn-In Errors
Default Baud
Error Log:
Bad Port Mask
Loop Test Error Description:
<errors>
The flash config/log area is initialized. This area is used by the Agent
code.
The POST tests are executed again.
Resets the switch
Comments? infodev@avaya.com
-PASSED
-PASSED
Result
5.0.0.xxx
done,
= 1.
= 0.
= DISABLED
= 9600
= 00000000
[ <all> ]:
[ 100 ]:
[ 0.0.0.0 ]:
[ 0.0.0.0 ]:
[ 255.255.255.0 ]:
March 2013