MAGEE Scientific AE33 User Manual page 29

Aethalometer
Model AE33
Insulate the sample lines inside the instrument shelter and avoid exposing them to direct
exhaust from the HVAC unit – this can lead to condensation inside the sample line tubing and
can damage the instruments and interfere with the measurement.
Thread the supplied fitting onto the Sample Inlet port on the rear panel of the Aethalometer
(Figure 7, top). Use Teflon tape on the thread. Fit the supplied barbed connector to the end of
the black conductive sample tubing and insert the connector into the fitting on the rear panel
of the instrument.
Figure 7. Fit the inlet connector on the rear panel of the Aethalometer and connect the sampling line
tubing to it.
Connect the other end of the sample line tubing to the sampling manifold or to the inlet on the
outside of the measurement station. Make sure that any openings in the station walls or ceiling
____________________________________________________________________________________________________________
User's manual – Ver. 1.53 July 2015 29/75