Sony HBD-E2100 Service Manual page 75

Pin No. Pin Name
50 STA516_XPDN
51 TAS5538_XRST
52 TAS5538_XMUTE
53 NO_USE
54 NO_USE
55 NO_USE
56 NO_USE
57 MIC_CLK
58 MIC_DATA
59 NO_USE
60 VCC2
61 NJU72341_POWER
62 VSS
63 PLUG_DET / MIC_IN
64 NO_USE
DRIVE_SD / POWER_
65
DET
66 BD_TEMP
67 STA516_TH_WARN
68 FL_CS
69 ASEL0
70 ASEL1
71 WOL_WLAN
72 NFC_RFDET
73 ST_RDS_INT
74 NAND_RESET
75 BD_SDI (IF_SDO)
76 BD_SDO (IF_SDI)
77 BD_SCLK
78 BD_CS
79 NFC_DATA
80 NFC_SPICLK
81 BD_RESET
82 JIG MODE1
83 OPWRSB
84 FE_EJECT
85 UPG_STATUS
86 NO_USE
87 KEY2_EJ
88 KEY1_EJ
89 KEY0
90 NO_USE
91 MODEL
92 DESTINATION
93 PCONT_WOL_STANDBY
94 AVSS
95 NO_USE
96 VREF
97 AVCC
98 NFC_SEL
99 PVDD_VOL_SEL
100 NO_USE
HBD-E2100/E3100/E3200/E4100/E6100
I/O
O DAMP Driver Standby Control
O Reset signal output to the DAMP processor "L": reset
O Muting on/off control signal output to DAMP processor "L": muting on
- No used
- No used
- No used
- No used
I/O Clock signal output terminal
I/O Serial data output terminal
- No used
- Power supply terminal (+3.3V)
O Power control for MIC IC
- Ground terminal
I Microphone plug insert detection signal input terminal "H": Microphone plug insert.
- No used
I Shut down signal input from the power amplifi er "L": detect
I Temperature detection signal input terminal
I Thermal warning for temperature of the IC STA516 more than 130 °C
O Chip select signal output to the fl uorescent indicator tube driver
O Audio selection signal output terminal
O Audio selection signal output terminal
I WOL wake up detect port input from BD decoder "H": detect
I RF signal input from the NFC module "H": detect
I RDS interrupt signal input from the FM receiver
O Reset signal output to the NAND fl ash "L": reset
O Serial data output to the BD decoder
I Serial data input from the BD decoder
I Serial data transfer clock signal input from the BD decoder
O Chip select signal output to the BD decoder
I/O Serial DATA input / output with the NFC module
O Serial interface clock output to the NFC module
O
Reset signal output to the BD decoder and EEPROM "L": reset
I/O Jig mode selection signal input from the BD decoder
I Power control signal input from the BD decoder
O Eject key input detection signal output to the BD decoder
I UPG status signal input from the BD decoder
- No used
I Key input terminal
I Key input terminal
I Power key input terminal
- No used
I Model setting terminal Fixed at "L" in this unit
I Destination setting
O Power Control for WOL / WOW function
- Ground terminal
- No used
I Reference voltage (+3.3V) input terminal
- Power supply terminal (+3.3V)
Data transfer direction and data transfer completion notifi cation signal output to the NFC
O
module
O No used
- No used
Description
Ver. 1.5
75