SATO CL408 Quick Manual page 8

CL408/412 Quick Guide
Plug-In Interface
Card
Interface
Connector
To complete the installation you will need the appropriate interface cable to
connect the printer to the output port of the host computer. These can be pur-
chased locally or from your SATO supplier. If you need additional informa-
tion on interface types, connector types or cabling pin-outs, please refer to
Section 5 of the Operator Manual.
The most common interface connections are Parallel and RS232 Serial.
Parallel Interface
The Parallel interface connector is an AMP 57-40360 female 36 pin Cen-
tronics type.
Pin # Description
1 Strobe
2-9 Data bits 0-7
10 Acknowledge
11 Busy
12 Out of Paper
13 +5VDC
17 Chassis Ground
31 Reset
32 +5VDC
16, 33
Signal Ground
19-30
There are no DSW configuration switch settings required for the parallel in-
terface.
PN 9001067 Rev A
18
1
19
36
Page 8