Yamaha PSR-S710 Service Manual page 64

PSR-S710/PSR-S910
Test No. LCD display
37 037 : Modulation Wheel Check
OK:
037 : Modulation Wheel Check
OK
42 042 : Pedal 1 Check
OK:
042 : Pedal 1 Check
OK
43 043 : Pedal 2 Check
OK:
043 : Pedal 2 Check
OK
45 045 : MIDI Check
OK:
045 : MIDI Check
OK
NG:
045 : MIDI Check
NG
46 046 : VIDEO OUT NTSC RGB
(PSR-S910 only)
47 047 : VIDEO OUT PAL RGB
(PSR-S910 only)
49 049 : USB to Device/Host Check
1:
049 : USB to Device/Host Check
Connect Device – Host
2:
049 : USB to Device/Host Check
Device – Host OK
3:
049 : USB to Device/Host Check
Connect USB Storage
OK:
049 : USB to Device/Host Check
OK
NG:
049 : USB to Device/Host Check
NG
64
Test descriptions, judging conditions, etc.
Checking MODULATION.
Turn the [MODULATION] wheel away from you to the end and then toward you to the end. When the
wheel is at maximum, C3 is played. When turned to minimum, C4 is played.
Check that "Modulation Wheel Check OK" is displayed on the LCD when the test is completed.
Checking the Pedal 1.
Connect the foot controller (FC7) to the [FOOT PEDAL 1] jack.
When the pedal is set to the minimum and C3 is played. When the pedal is set to the maximum and G3 is
played.
Disconnect the foot controller from the [FOOT PEDAL 1] jack and C4 is played.
Check that "Pedal 1 Check OK" is displayed on the LCD when the test is completed.
Checking the Pedal 2.
Connect the foot controller (FC7) to the [FOOT PEDAL 2] jack.
When the pedal is set to the minimum and C3 is played. When the pedal is set to the maximum and G3 is
played.
Disconnect the foot controller from the [FOOT PEDAL 2] jack and C4 is played.
Check that "Pedal 2 Check OK" is displayed on the LCD when the test is completed.
Checking MIDI.
Connect the [MIDI IN] connector and [MIDI OUT] connector with a MIDI cable and then execute the test.
Check that C4 is played and "MIDI Check OK" is displayed on the LCD.
Checking Video OUT.
Connect an appropriate display monitor to the [VIDEO OUT] jack.
Check that RGB color code is shown on the display monitor when the test is executed.
Checking Video OUT.
Connect an appropriate display monitor to the [VIDEO OUT] jack.
Check that RGB color code is shown on the display monitor when the test is executed.
Checking USB Device/Host.
Enter the test with the [START/STOP] button and "Connect Device – Host" will be shown on the
LCD.
When a USB cable is connected to the [USB TO DEVICE] and [USB TO HOST] connectors, "Device –
Host OK" is shown on the LCD and quickly followed by "Connect USB Storage".
Disconnect the USB cable from the [USB TO DEVICE] and [USB TO HOST] connectors and then con-
nect a USB storage device to [USB TO DEVICE] connector. Check that C4 will be played and "USB to
Device/Host Check OK" will be shown on the LCD.