Advertisement
Controls
1. POWER ON/OFF button (1)
Push the PWR button (1) to turn on the unit. Push the button again to turn off the unit.
2. SEL and VOL button (2)
1) Audio control ( VOLUME / BASS / TREBLE / BALANCE / FADER )
By quickly pressing the SEL (2) button, you can select which of the below features to set:
-VOL display - volume control > press button (2)>
-BAS display - bass tone control >press button (2)>
-TRB display - treble tone control > press button (2)>
-BAL display - balance control > press button (2)>
-FAD display - fader control > press button (2)>
Use the VOL up/down button (16) to adjust. In each mode, the waiting time for adjustment
is about 5 seconds. If the waiting time is over, the unit returns to the last displayed mode
of Radio, USB/NAND (internal memory), CDC, iPod, SIRIUS or CD mode. These settings
are indicated on the display window.
VOLUME
Select
FADER
Select
2) Beep 2nd , I-Vol , Area and DSP Selection
When the SEL button (2) is held over 2 seconds, the unit will be operated as below:
Beep 2nd
I-Vol
Press
Press
a. Beep 2nd
In the Beep 2nd mode, you can control Beep on or Beep 2nd by pressing VOL up/down.
- Beep on : You can hear "beep" sound when you press any buttons.
- Beep 2nd : You can hear "beep" sound when you press any button over 1.5 seconds.
b. I-Vol
By pressing the SEL(2) button again, the unit will turn to I-VOL mode (Initial Volume Level
Adjustment). You can adjust the I-Vol to the level you want by using VOL up/down button.
After setting the initial level, the volume will default to this level every time the unit is
powered on.
c. Area Selection
By pressing SEL(2) button again, the unit will be in Area selection mode, then use VOL
up/down button to choose USA or EUR. Press and hold BD/FN for 2 seconds to confirm
and save selection.
d. SUB-W
By pressing SEL(2) button again, the unit will be in Sub-woofer selection mode, then press
VOL up/down button to choose SUB-W on or off.
e. DSP
Choose from flat, classic, pop or rock by pressing the SEL(2) button again. Adjust with
VOL up/down button.
4
BASS
TREBLE
Select
BALANCE
Select
Select
Area
SUB-W
DSP
Press
Press
Controls
3.Volume control
Press the VOL up/down button to increase or decrease the volume level.
- Bass control
Press VOL up to increase the bass.
Press VOL down to decrease the bass.
- Treble control
Press VOL up to increase the treble.
Press VOL down to decrease the treble.
- Balance control
Press VOL up to decrease the left speaker volume.
Press VOL down to decrease the right speaker volume.
- Fader control
Press VOL up to decrease the volume level of speakers connected to the rear channel.
Press VOL down to decrease the volume level of speakers connected to the front channel.
4."MODE" button (3)
Press this button to select Radio, CD, USB/NAND (internal memory), CDC, SIRIUS
or AUX.
5. BD/FN button (4)
In radio mode, press the BD/FN(4) button shortly to select the desired band:
FM1,FM2,FM3, AM1 and AM2.
In SIRIUS mode, press BD/FN (4) button to select the SSR1, and SSR2.
7. How to adjust the clock / time (8)
Press DIS(8) button once to display the time.
a. Press and hold the DIS (8) button until the time flashes on the display.
b. Press VOL up to set hour.
c. Press VOL down to set minutes.
d. Press the DIS button again quickly to accept the adjusted time.
If no button is pressed within 5 seconds, then the unit automatically accepts the
adjusted time without further intervention from the user.
8. Loudness function (14)
In order to emphasize the bass and the treble at low volume, press the LD (14) button.
To turn off loudness, press the LD button again.
Station Tuning
1
. Manual/Seek tuning buttons (15): Press this button quickly to activate the Seek
mode. The Seek mode will automatically seek up or down the wave band and stop at
the next station of sufficient signal strength. Press and hold tuning buttons for 2
seconds to enter manual tuning mode. The unit will revert back to Seek mode after
10 seconds without use.
5
Advertisement
