Denon D-107 Service Manual page 11

QQ
3 7 63 1515 0
3. Back Cabinet, Front Cabinet
1) Remove 10 screws
2) With holding the Back Cabinet, pull both sides of the Front
Cabinet in the arrow direction.
Note: Use a rubber hammer etc. to hit the
of the Front Cabinet if it's hard to remove.
3) Push the Front Cabinet to the arrow direction to make a
gap between the Back Cabinet.
4) Cut the wire clamp band near the Front Cabinet, and
disconnect 4 cables on the Pre Amp Unit.
5) Disconnect 2 cables on the bottom of the Pre Amp Unit,
and separate the Back and Front Cabinet.
4. Pre Amp Unit, Transformer
1) Remove 4 screws
TE
L 13942296513
2) Remove 4 screws
5. Speaker Unit
1) Pull out the Decoration Ring in the arrow direction.
2) Remove 4 screws
Note: When disconnecting the cables from terminals of
the Speaker Unit, make it at the position where the
terminals of the Speaker Unit can be seen from the
Back Cabinet. The clamp part of the internal
speaker cables will be disengaged if separated
www
farther.
.
http://www.xiaoyu163.com
.
9
arrow part
to detach the Pre Amp Unit.
1 0
to detach the Transformer.
1 1
1 2 to detach the Speaker Unit.
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Front Cabinet
Wire Clamp
Band
Q Q
3 6 7 1 3 1 5
1 0
co
.
9 4 2 8
Back Cabinet
9
Pre Amp Unit
1 1
1 0
0 5 8 2 9 9 4 2 8
1 1
1 0
Pre Amp Unit
Speaker Unit
m
1 2
Decoration Ring
1 2
D-107
9 9
9
9 9
11