Operation With Tape; Playing A Tape; Cm (Commercial Message) Skip; Opr (Optimum Picture Response) - LG LH-C6230 Owner's Manual

Operation with tape

Playing a tape

You will only be able to load and eject video cassettes
when your DVD/CD/VCR receiver is plugged into the
mains.
Your DVD/CD/VCR receiver may also play back record-
ings from NTSC tapes (on PAL TV).
Getting a better picture
When a cassette is inserted and playback started, the
automatic tracking function works to get the best possi-
ble picture automatically. If the quality of the recording is
poor, repeatedly press either PR/TRK (v v /V V ) on the
remote control or PROG/TUNING (v v /V V ) on the front
panel to manually adjust the tracking until any distor-
tions have been removed. Press numbered button 0 on
the remote control to switch automatic tracking back on
again.
Make sure that you have correctly connected
1 1
your DVD/CD/VCR receiver as described earlier
in this book.
Turn on your TV.
Press POWER to turn on your DVD/CD/VCR
receiver.
Insert the video cassette into your DVD/CD/VCR
receiver.
The video cassette should have the window side
facing up and the arrow facing away from you.
Press PLAY (H H ) to start playing your tape.
2 2
If you load a video cassette which has had its
record protection tab removed, playback of the cas-
sette will start automatically.
AUTO TRACKING
Your DVD/CD/VCR receiver will automatically adjust
the tracking to give the best picture quality.
Press PAUSE/STEP (X X ) to still a picture.
3 3
Press PAUSE/STEP (X X ) repeatedly to advance
the tape frame by frame.
If you press FORWARD, the picture will be slowed
down at about 1/19 times the normal playback.
Tapes can be paused for up to 5 minutes. After 5
minutes your receiver will stop the tape to prevent
from damage to the tape or your receiver.
Still picture quality can be improved slightly by
pressing PR/TRK (v/V) on the remote control.
Press PLAY (H H ) to continue playing your tape.
4 4
Picture search:
During playback press either FORWARD or BACK-
WARD. This will enable you to rapidly wind the tape
(7 times normal playback) while seeing where you
are on the tape.
Logic search:
During fast forward or rewind press and hold FOR-
WARD or BACKWARD. The picture will be played
back at 7 times normal playback speed.
24
During playback or still picture press
5 5
You can reach the following playback speeds.
(-7xplay, -3xplay, -play, still, 1/19 slow, play, 2xplay,
7xplay)
To switch off the slow motion and shuttle, press the
desired function.
During slow motion and shuttle, the noise bars may
appear on the picture according to the status of
tape.
If distortions can be seen in the picture, reduce
them with PR/TRK (v/V) on the remote control.
Press STOP (x x ) to end playback.
6 6
Press EJECT.
If the end of the tape is reached, your DVD/CD/
VCR receiver will stop playback automatically,
rewind, stop at the top of the tape, eject the tape
then power off.

CM (Commercial Message) Skip:

When playing back tapes, this feature lets you skip
through commercial breaks by fast-forwarding, and
then resume normal playback.
While tape is playing press CM SKIP on the remote
control to skip commercial (or other programme
material).
Repeatedly press CM SKIP to skip:
The tape will fast forward picture search through 30
seconds of recording for each press of the button.
1 Press 30 seconds
2 Presses 60 seconds
3 Presses 90 seconds
4 Presses 120 seconds
5 Presses 150 seconds
6 Presses 180 seconds

OPR (Optimum Picture Response):

This feature automatically improves playback picture
quality by adjusting your DVD/CD/VCR receiver to the
condition of the tape.
Press i.
1 1
Press F F or G G to select OPR and press OK.
2 2
1 2
OFF
Pr-12
P SET
TIME
REC SOFT
ACMS
R
DATE
f SHARP
OSD OSD
NIC
ON 16:9
OPR
OFF 4:3
Press D D or E E repeatedly to select: OFF, SOFT or
3 3
SHARP.
Please note you may set OPR only when playing back
a tape.
Press i to remove the menus from the TV
4 4
screen.
F F or G G .
A B
VCR
C
SYS-
Dr.
TEM OSD
OPR
i