Sound Pressure Level; Sound Power Level; Vibration Level; Safety And Instruction Decals - Toro ProCore 648 Operator's Manual

• Keep all parts in good working condition and all
hardware tightened. Replace all worn or damaged
decals.
• Use only Toro-approved attachments. Warranty may
be voided if used with unapproved attachments.

Sound Pressure Level

This unit has an equivalent continuous A–weighted sound
pressure level at the operator ear of 84 dBA, based on
measurements of identical machines per Directive
98/37/EC and amendments.

Safety and Instruction Decals

Safety decals and instructions are easily visible to the operator and are located near any
area of potential danger. Replace any decal that is damaged or lost.
1. Read the Operator's Manual.
2. Engine—stop
3. Engine—run
4. Engine—start
106-8854
5. Read the Operator's Manual;
move the switch up to turn
ground following on; move
the switch down and install
the spacers to turn ground
following off.

Sound Power Level

This unit has a guaranteed sound power level of:
102 dBA/1 pW, based on measurements of identical
machines per Directive 2000/14/EC and amendments.

Vibration Level

This unit does not exceed a vibration level of 2.5 m/s@ at
the hands based on measurements of identical machines
per ISO 5349 procedures.
This unit does not exceed a vibration level of .5 m/s@ at
the posterior based on measurements of identical
machines per ISO 2631 procedures.
6. Read the Operator's Manual;
press the switch to test the
safety system.
7. To start the engine, turn the
ignition key and unlock the
parking brake; read the
Operator's Manual.
5
8. To stop the engine, press the
switch to disengage the PTO,
lock the parking brake, and
turn the ignition key to the
Stop position and remove it;
read the Operator's Manual.
9. Transport or hole spacing
selection