Install Tine Holders, Turf Guards And Tines - Toro ProCore 648 Operator's Manual

Figure 22
1. Service latch in (raised) locked position
Install Tine Holders, Turf
Guards and Tines
A wide selection of tine holders, turf guards and tines are
available for the aerator. Choose the required components
per the accessory chart on page 10.
1. Raise coring head and lock in position with service
latch.
2. Mount a tine holder to each tine arm with (3) 1/2 x
1–1/4 in. capscrews (Fig. 23). Torque capscrews to
75 ft.–lbs. (Capscrews provided in tine holder kits)
Figure 23
1. Tine arm
3. Loosely install the turf guards to the turf guard
brackets with (12) carriage bolts, flat washers and
flange nuts (Fig. 24). Do not tighten the fasteners.
Carriage bolt heads to be positioned under turf guard
brackets.
1
1
2
2. Tine holder
22
2
Figure 24
1. Turf guard
4. Loosely install a tine clamp to each tine holder with
(4) 3/8 x 1–1/2 in. capscrews. (Fig. 26) Do not tighten
capscrew.
5. Install tines into the #2 and #5 tine holders (Fig. 25)
Tighten the capscrews.
1
Figure 25
1. Number 5 tine holder
Figure 26
1. Tine clamp
1
2. Turf guard bracket
GRAPHIC #
2
1. Number 2 tine holder
1
2
2. Tine