Cleaning And Filter Care - Zephyr ZSI-E36AS Use, Care And Installation Manual

SURFACE MAINTENANCE:
Clean the hood surface periodically with hot soapy water and clean cotton cloth. Do not use corrosive or
abrasive detergent, or steel wool/scouring pads which will scratch and damage surface.
For heavier soil use liquid degreaser.
After cleaning it is recommended that you use non-abrasive stainless steel polish/cleaners, to polish and
buff out the stainless luster and grain. Always scrub lightly, with clean cotton cloth, and with the grain.
Do not use any product containing chlorine bleach. Do not use "orange" cleaners.
Baffle Filters
The baffle filters installed by the factory are intended to filter out residue and grease from cooking. They
need not be replaced on a regular basis but are required to be kept clean.
Remove and clean by hand or in dishwasher on low heat. Spray degreasing detergent and leave to soak if
heavily soiled.
Dry filters and re-install before using hood.
Removing Baffle Filters
1. Push in on spring loaded handle
2. Pull down on filter hande to remove filter
Should filters wear out due to age and prolonged use,
replace with following part number:
Hood Model:
ZSI
Part No. Qty. to Order.
50200050 2
13