Installing The Stove; Preparation; Attaching The Freestanding Base - Appalachian Stove & Fabricators 52-Bay Installation And Operation Procedures

Table of Contents

Advertisement

3. INSTALLING THE STOVE

NOTE: Walls or wood frame construction covered with
noncombustible veneer, such as brick, are considered
COMBUSTIBLE walls.
A) If the stove is installed on a combustible floor, a
protective pad of 3/8" fireproof millboard, or equivalent,
must be placed beneath the pedestal. It must extend 8" to
either side of the stove and 16" in front of the stove.
B) If the stove pipe is installed with an elbow to penetrate
the wall into a flue, the minimum clearance of the elbow is
18" from the top of the stove pipe and the ceiling.
RESIDENTIAL CLEARANCE DIMENSIONS:
Combustible Wall-Single Wall Pipe
Combustible Wall-Insulated Pipe
Combustible Wall-Insulated Pipe-Heat Shield
Non-Combustible Wall-Single Wall Pipe
Combustible Wall-Double Wall Air Cooled
Pipe with Heat Shield

4. PREPARATION

Proper preparation and planning of the installation will
simplify the job and help achieve effective operation of the
unit.
A) Select the location of the stove installation. The stove
should be positioned so that the air flows to the rest of the
home in as straight a line as possible.
B) Indicate the proper penetration point of the chimney
structure. Avoid roof areas such as valleys, ridges, dormers
and hips.
Position the floor protector where the installation is to be
made (Section II).
Attach the pedestal to the stove and place into position on
the floor protector. Check clearances.

5. ATTACHING THE FREESTANDING BASE

Tool Needed: Drill
A) Remove the wooden blocks from the stove bottom. A
drill may be used to remove the screws.
B) PEDESTAL: Position on stove bottom so that it is
centered and 2" back from the edge of the stove bottom.
The longest solid panel and the opening in the bottom of
the pedestal are located at the front of the stove. The
pedestal should be placed with the "turned out" flange
against the bottom. LEG KIT: There are holes drilled on the
bottom of the stove that will line up the legs properly. The
legs are attached with screws from the bottom of the stove.
R
S
24"
24"
18"
24"
6"
24"
12"
12"
14"
18"
FIGURE 6
CLEARANCE TO COMBUSTIBLES
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents