Table of Contents
Advertisement
V . INSTALLING THE BRASS TRIM
1. STANDARD BRASS
(A) Spring damper handle - screw the handle onto the
damper rod counter-clockwise.
2. OPTIONAL BRASS
A) GOLD PLATED DOOR WEBBING/CAST WEBBING
1. For ease of installation, remove the door from the
stove. The door can be removed from its hinges with the
proper leverage.
FIGURE 10
2. The air channel can then be taken off by removing the
four screws. Remove the glass.
3. Place the webbing in the center of the opening. If the
door is cast and the webbing is brass, it may be a tight fit.
Make sure that the webbing drops down completely.
NOTE: The door may also be replaced, if desired. It also
comes in the option of gold plated or cast black.
B) BRASS TRIM PANELS
1. Mount top and side strips to trim panels with the self
tapping brass screws that are provided. Leave
approximately 1" at top edges of trim to be covered by
corner brass. If needed, strips can easily be cut with a
hacksaw.
2. Mount two brass corners overlapping top and side
brass strips.
3. Remove protective coating from brass strips before use.
FIGURE 11
FRONT EDGE BRASS
11
Hide quick links:
Advertisement
Table of Contents
