Table of Contents
Advertisement
Troubleshooting
Problem
Possible cause
Appliance fails to op-
• The laundry has reached the dry
erate and the display
level defined by the programme?
shows End.
• There is no laundry in the drum?
The drying results
• The program setting is not cor-
rect?
are not satisfactory. .
• The correct dry level was chosen?
• The filter is dirty?
• The condenser filter is dirty?
• The heat exchanger is clogged?
• The ventilation slots are clogged?
• The tumble dryer is overloaded?
• There is a coating on the inner
surface of the drum?
• The laundry was too wet?
• Dirt is on the moisture sensor in
the drum?
• Warm laundry feels more moist
than it really is.
Drying time is too
• The condenser filter is dirty?
• The tumble dryer is overloaded?
long.*
• The laundry was too wet?
• Ambient temperature is too low?
Drying time is too
• The load was too small?
short..
• The laundry was too dry?
Creasing at the
• The tumble dryer is overloaded?
laundry.
• The right programme was select-
ed?
Door does not close. • Laundry is clamped between door
and gasket?
* The drying cycle is automatically cancelled after 5 hours.
28
GB
Possible solution
• Check the program setting and
post-dry if necessary.
• Check the drum.
• Check the program setting.
• Check the dry level.
• Clean the lint filter.
• Clean the condenser filter
• Clean the heat exchanger.
• Clean the ventilation slots.
• Reduce the amount of laundry.
• Clean the inner surface of the
drum with a cloth soaked in vin-
egar.
• Spin the laundry properly before
drying.
• Clean the front surface of the
drum with a cloth soaked in vin-
egar.
• Spread out laundry that the heat
can escape. .
• Clean the condenser filter
• Reduce the amount of laundry
• Spin the laundry properly before
drying.
• Pay attention to the installation
instructions. and increase the
ambient temperature, if possible.
• For single items or small amount
of laundry the TIME programme
should be selected.
• Select the TIME programme or a
higher dry level.
• Reduce the amount of laundry.
• Remove laundry immediately af-
ter programme end, hang them
up and pull them into shape.
• Select and adjust the programme
according to the fabric type.
• Insert laundry correctly.
GB
Problem
Possible cause
Remaining time on
• The remaining time will be adjusted
continuously based upon the fol-
the display stops or
lowing factors:
skips.
- Type of laundry.
- Loaded amount.
- Moisture degree of the laundry.
- Ambient temperature.
The drum inte-
• Appliance is connected to the
rior light does not
power supply?
work..
• The appliance has been switched
on?
• The light bulb is still functional?
Strong rumbling
• The dryer rack is not properly in-
noise
stalled.
In case of power failure
In case of power failure, the current programme is stored only for a short time. Usually, a
restart of the program is required.
WARNING!
Quickly remove all items and spread them out that the heat can be released.
Troubleshooting
Possible solution
• The automatic adjustment is a
normal operation.
• Check power supply
• Switch the machine on.
• Contact the customer service to
replace the lamp.
• Correct the seat of the dryer rack.
29
Advertisement
Table of Contents
