Clutch Assembly - PIAGGIO Ape Workshop Manual

Engine
After performing the above operations, extract the
roller bearing (8) using the specific extractor (7)
equipped with component 1 and 9.
Specific tooling
T.0021467 Bearing extractor
T.0035731 Flywheel extractor and differential
housing

Clutch assembly

CAP LOCK RING AND MULTI-GEAR AXLE NUT
Using the specific key (1) unlock the nut (2) and
remove the cap (3).
Remove the clutch cover and with the specific key,
lock the unit; then with a T-shaped wrench of 19
mm. unscrew the nut (4) of the multi-gear pin.
Specific tooling
T.0030632 Wrench for helical gear nut
T.0031729 Clutch stop key
CLUTCH ASSEMBLY - REMOVAL
Lock the assembly with the appropriate key (1) and
unscrew the lock nut.
Apply the extractor (3) using the 3 screws (2) fixing
the plates, and act on the central screw (4) until
the assembly is extracted; if it does not occur it is
necessary to act by means of mallet blows on the
periphery of the clutch housing to loosen up the
cone and thus cause the extraction of said clutch.
Specific tooling
19.1.20046 Clutch puller
EN - 82
APE TM Benzina