Roller Bushing 2Nd Expulsion - Removal/Installing - PIAGGIO Ape Workshop Manual

APE TM Benzina
ROLLER BUSHING 2ND EXPULSION - REMOV-
AL
(Manual operation that does not require the use of
the press).
To expel the second roller, use the component 22
and hit with the mallet.
INSTALLING
CAUTION
DURING THE REMOVAL OPERATIONS DESCRIBED ABOVE, THE ROLLER BUSHINGS ARE DE-
STROYED WHEN THE PRESS IS USED.
THEREFORE, UPON FITTING, NEW BUSHINGS MUST BE USED, AS IT IS ALWAYS NECESSARY
TO USE NEW PIN, SEALING RINGS AND DUST GUARD.
WARNING
IF AT THE END OF THE REMOVAL OPERATIONS OF THE WEDGE WASHERS AND IN PARTIC-
ULAR OF THE PIN, SIGNS OF DETERIORATION SHOULD BE NOTICED IN THE AREA WHERE
THE ROLLER BEARINGS ARE HOUSED, IT IS ALWAYS ESSENTIAL TO PROCEED TO THE RE-
PLACEMENT OF THE ARM.
PIN - INSTALLATION
- Connect by hand the swinging arm to the steering tube by means of the guide pin comp. 12.
N.B.
BEFORE PROCEEDING TO MAKE THIS CONNECTION, INSTALL THE TWO DUST GUARD RINGS
(1) ON THE SWINGING ARM.
Suspensions
SS - 121