Periodic Maintenance; What To Do If - AEG HG995440XB User Manual

32

What to do if...

• You can remove the pan supports to easily clean the hob.
• To clean the enamelled parts, cap and crown, wash it with warm soapy water and dry it
carefully before you put them back.
• Stainless steel parts wash with water, and then dry with a soft cloth.
• The pan supports are not dishwasher proof; they must be washed by hand.
• When you wash the pan supports by hand, take care when you dry them as the enamel-
ling process occasionally leaves rough edges. If necessary, remove stubborn stains using a
paste cleaner.
• Make sure you position the pan supports correctly after cleaning.
• To make burners work correctly, make sure that the arms of the pan supports are in the
centre of the burner.
• Be very careful when you replace the pan supports to prevent the hob top from
damage.
After cleaning, dry the appliance with a soft cloth.
Removing the dirt:
1. – Remove immediately: melting plastic, plastic foil, and food containing sugar.
– Stop the appliance and let it cool down before you clean: limescale rings, water
rings, fat stains, shiny metallic discolorations. Use a special cleaner for glass or stain-
less steel.
2. Clean the appliance with a damp cloth and some detergent.
3. At the end rub the appliance dry with a clean cloth.
Cleaning of the spark plug
This feature is obtained through a ceramic ignition candle with a metal electrode. Keep
these components well clean to prevent difficult lighting and check that the burner crown
holes are not obstructed.

Periodic maintenance

Periodically speak your local Service Force Centre to check the conditions of the gas supply
pipe and the pressure adjuster, if fitted.
WHAT TO DO IF...
Problem
There is no spark when lighting
the gas
Possible cause
• There is no electrical supply
• Burner cap and crown are
placed uneven
Remedy
• Make sure that the unit is
connected and the electrical
supply is switched on.
• Control the fuse. If the fuse
is released more than one
time, refer to a qualified
electrician.
• Make sure that the burner
cap and crown are in correct
positions.