Table of Contents
Advertisement
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice, even if the appliance is still under
guarantee!
Fault
Temperature differs
greatly from the set
value.
Display indicates E..".
Fig. 2/2
Light does not function.
Fascia has reduced
luminosity.
Displays do not
illuminate.
Downloaded from Fridge-Manual.com Manuals
Possible cause
Electronics module defective.
The bulb in the refrigerator
compartment or freezer
compartment is defective.
Light switch is sticking. Fig. 1/3
When the appliance is not used for
about twenty four hours the display
on the fascia switches to ECO
mode.
Power failure; the fuse has been
switched off; the mains plug has
not been inserted properly.
Remedial action
In some cases it is adequate to switch
off the appliance for 5 minutes.
If the temperature is too high wait
a few hours and check whether the
temperature has approached the set
value.
If the temperature is too low, check
the temperature again the next day.
Call customer service.
Replace bulb. Fig. w
1. Pull out the mains plug or
disconnect the fuse.
2. Change the bulb
(Philips T25 HD" replacement
bulb, max. 15 W, 220-240 V a.c.,
E14 bulbholder).
Check whether it can be moved.
As soon as the appliance is again
used, e.g. the door is opened, the
display switches back to normal
illumination.
Check whether the power is on,
the fuse must be switched on.
en
79
Advertisement
Table of Contents
