Install The Ceiling Fan; Using Flush Mounting System; Blade And Blade Arm Assembly - CONCORD 52HED Owner's Manual And Installation Instructions

Step 4 Install the ceiling fan
If you are using the Flush Mount System, skip
this step and go to step 4a.
Slide the ceiling canopy up into place over the
ceiling mounting bracket (see figure 11). The
two screws on the mounting bracket face
should slip through the key hole slots in the
canopy. Rotate the canopy slightly and then
tighten both screws.
Depending on how deep the electrical
junction box was installed in the ceil-
ing, you might have a slight gap
between the ceiling canopy and the
ceiling. Junction boxes are commonly
installed at different depths in the ceil-
ing, so we have designed the mounting
bracket and ceiling canopy to allow for
this.
Step 4a OPTIONAL

Using Flush Mounting System

Attach Canopy to top of Motor Housing using
three (3) screws and lock washers supplied (see
figure 11a).
Step 5 Blade And Blade Arm Assembly
This fan is supplied with a reversible blade fin-
ish. Choose the blade finish that you prefer and
attach as follow:
Attach each fan blade to a blade arm with three
washer head screws and three screw pads (see
figure 12). Each screw is passed through the
screw pad, then the blade and screwed into the
blade arm.
Screws should be tightened until the screw pads
are compressed. Hold the blade arm decorative
side down and place the blade on top with your
choice of finish facing down.
8
Canopy Screws
Ceiling Canopy
Canopy
Motor Housing
Screws and Pads (3 per blade)
Support Rod
Fig. 11
Screws and
Lock Washers
Fig. 11a
Fig. 12