Attach The Support Assembly - CONCORD 52HED Owner's Manual And Installation Instructions

Fig. 4
Retaining Clip
& Washer
Motor Leads
Ceiling Canopy
Fan Motor
Assembly
Fig. 5
Half Ball Hanger
Safety Pin
Threaded end of
Support Rod
Support Rod
Set Screws
Support Rod Coupler
Pull the electric wires in the junc-
tion box down through the mount-
ing bracket then bend them up and
back out of the way.
black wire to one side and the white
and ground wire to the other side (see figure 4)
The wires should be off to the side and up against
the ceiling. This will leave the mounting bracket
open and ready to receive the ceiling fan.
Step 2 Attach the support assembly
If you are using an extended support rod,
(longer than the one supplied with your fan)
remove the half ball from the support assem-
bly and attach it to the extended support rod
at this point. Make sure to retighten the set
screw and insert the safety pin.
Back off (loosen) the set screws (2) in the sup-
port rod coupler until the inside of the channel
is clear of the screw tip.
Remove and save the safety pin on the end of
the support rod assembly.
Place the ceiling canopy face down (small end)
over the support rod coupler on the motor hous-
ing.
Feed the electrical wires from the fan housing
through the support rod.
Thread the support rod into the support rod cou-
pler until the safety pin can be inserted through
the hole in both the rod and coupler.
Insert the safety screw through the hole in the
support rod coupler and support rod then attach
the washer and retaining clip on the other side.
Tighten both set screws and safety screw on the
support rod coupler.
Place the
5