Making The Electrical Connections - CONCORD 52HED Owner's Manual And Installation Instructions

Black
Blue
Fig. 9
Black
Blue
Fig. 10
Green
White
White
Green

Making the electrical connections

To operate your ceiling fan with the pull chain(s)
and switches mounted on your fan, follow the
instruction below (see figure 9).
If you require or would like to
use a different method of con-
trolling your fan, refer to the
Optional Electrical Wiring
Procedures on page 10.
Attach the GREEN wire (connected to the half
ball) to the GROUND wire in the junction box.
The GROUND wire is usually a bare copper
wire without plastic insulation. It could also be
covered in green plastic insulation.
Attach the BLACK wire and BLUE wire from
the ceiling fan to the BLACK wire in the junc-
tion box.
Attach the WHITE wire from the ceiling fan to
the WHITE wire in the junction box.
Each of the above connections
should be made as tight as pos-
sible using the proper size plas-
tic wire nuts. Plastic electrical
tape is not recommended for
these connections.
Fold the connected wire (see figure 10) and push
them up inside the electrical junction box with
the BLACK and BLUE wires to one side and the
WHITE and GREEN to the other side. Make
sure the wire nuts do not come loose during this
operation.
7