Related Manuals for CONCORD Aracruz 52AC
Summary of Contents for CONCORD Aracruz 52AC
-
Page 1: Installation Instructions
Aracruz ™ ® 52AC Owners Manual Installation Instructions Part Number: PL-3238 (Revised 05.02.07) A Commitment to Excellence... - Page 2 50 pounds of moving weight and marked “Acceptable for Fan Support”. If you have any questions, outlet boxes and support systems for ceiling fans are available at most hardware and do-it-yourself centers. In most cases, your Concord ® dealer will have all the necessary products for the proper and safe installation of your ceiling fan.
- Page 3 This ceiling fan was not designed for installation in any location where it might be exposed to moisture or high humidity. Installation in this type of location could be UNSAFE, will most likely damage the fan and its finish... and will VOID YOUR WARRANTY. Every effort has been made to provide you with proper instructions for the safe installation of this ceiling fan.
-
Page 4: Turned Off
Junction Box Have you TURNED OFF the Electricity? Step 1 Attach the mounting bracket Mounting Bracket Loosen the two canopy mounting screws on the downside face of the mounting bracket. Back them out about half way. This will allow for Washer easier installation of the ceiling canopy later (see figure 1). - Page 5 Step 2 Attach Motor Housing to Motor Motor Insert the motor housing onto motor Place motor housing cover onto motor, line up the 3 keyway holes rotate plate; locking it into place. Insert single screw and tighten (see figure 3). Tighten other 3 keyway screws.
- Page 6 Dust Cover Socket Step 4 Putting bulbs in top of fan Remove screws holding clear dust cover down. Screw bulbs (4) -included with your fan- into the sockets located in the top of the fan motor hous- ing (see figure 5). Place clear dust cover back over bulb area.
- Page 7 Mounting Bracket Keyway Pin Ball Hanger If you are going to use an RM-08 Control Unit with this fan, refer to the Installation Manual for the RM-08 before proceeding further. Support Rod Fig. 7 Step 5 Making the Electrical Connections To operate your ceiling fan with the pull chain(s) and switches mounted on your fan, follow the instructions below:...
- Page 8 Cover Step 8 Fan Blade and Blade Arm Assembly Fig. 10 Most CONCORD fans are supplied with a reversible blade finish. Choose the blade finish Screw that you prefer and attach as follow: Attach each fan blade to a blade arm with four (4) 3/16”...
- Page 9 Step 9 Fan Blade Assembly Installation Remove the large screws in the face of the motor. Discard any rubber blocks attached to these screws. The rubber blocks are installed at the factory to stabilize the motor during ship- ment. Fan Blade Attach each blade to the motor face using the two screws attached to the blade arm (see figure 12).
- Page 10 If you are going to use an RM-08 Control Unit with this fan, refer to the Installation Manual for the RM-08 before proceeding further. Switch Motor Step 10 Electrical Switch Housing Installation Housing Housing Connector Connector Back off (loosen) the three screws on the electri- cal housing mounting plate attached to the motor shaft (see figure 15).
- Page 11 SWITCH THAT HAS BEEN DESIGNED FOR USE WITH CEILING FANS Your dealer carries a number of different types of CONCORD wall switches that have been Fig. 17 designed and tested for use with our products. To obtain the best performance electrical com- ponents should be matched for output, for that Fan &...
-
Page 12: Maintenance
No part of this publication may be produced, transmitted, transcribed, stored in a retrieval system, or translated into any language ® in any form by any means without the written permission of Great 2000 Enterprises, Inc.. Concord Fans and Lighting is a division of Great 2000 Enterprises, Inc.