Csx‐Live 218 - Martin Audio CDD-LIVE! Series User Manual

CDD‐LIVE
CSX‐Live 218
Acoustics
TYPE
FREQUENCY RESPONSE(3)
DRIVER
INPUT SENSITIVITY
MAXIMUM SPL (4)
DISPERSION
CROSSOVER
Audio input
CONNECTORS
ANALOGUE INPUT IMPEDANCE
MAXIMUM ANALOGUE INPUT LEVEL
Internal Processing
Network
CONNECTORS
PROTOCOL
Amplifier Module
TYPE
PEAK OUTPUT POWER
CONTINUOUS OUTPUT POWER
AVERAGE EFFICIENCY
COOLING
MAXIMUM AMBIENT TEMPERATURE
Power Supply
TYPE
AC INPUT OPERATING RANGE
POWER FACTOR
NOMINAL POWER CONSUMPTION
MAINS CONNECTOR
Mechanical
ENCLOSURE
FINISH
PROTECTIVE GRILLE
FITTINGS
IP RATING
DIMENSIONS
WEIGHT
ACCESSORIES
Notes
(1) Measured on-axis in free space (4π space) at 2 metres, then referred to 1 metre
(3) Measured on-axis on ground plane (2π space) at 2 metres, then referred to 1 metre
CDD‐LIVE User Guide V1.0
USER GUIDE
Dual-driver, direct radiating powered subwoofer
35Hz – 150Hz ±3dB, -10dB @ 30Hz
2x 18" (460mm)/4" (100mm) voice coil, long excursion, ferrite magnet, waterproof cone
-20dBu for 100dB SPL (CDD12/15 pre-set)
-13dBu for 100dB SPL (CDD8 pre-set)
140dB continuous / 143dB peak
Omnidirectional / or Cardioid (paired)
Active
Presets for CDD-Live 8, 12 & 15 mono-pole or cardioid (paired)
Female XLR input, male XLR link output, Dante Audio Neutrik® Ethercon
20 kΩ balanced to ground
24.6 Vpp (+21dBu), over voltage protected
Multi-channel DSP, programmable via TCP/IP using VU-Net software
PEQ/shelving filters
Up to 48dB/Oct LPF
Up to 200mS input delay
Pre-set selection via rear panel switch
2xNeutrik® EtherconRJ45
TCP/IP and UDP/IP
Two 2 channel switch-mode, class D, Bridged Tied Load
4000W
2000W
89%
External fan
40°C (104°F) for full output
Switch mode, fixed frequency with PFC
85 – 265V ~ AC, 50 - 60Hz
> 0.98
550W
Neutrik® PowerCon True1
Extensively braced multi-laminate birch plywood
Textured black PU coating
HEX perforated mild steel with protective zinc plating and black powder coat finish
Two skids on base, with mating channels on top
Four rear-mounted 100mm (4in) castors
24 x M10 mounting points
4x Bar handles, 2 on each side
4x fittings for optional transit cover
Optional weather protection cowl
IP24 factory option available
(W) 1085mm x (H) 537mm x (D) 792mm (920mm including castors)
(W) 42.72in x (H) 21.13in x (D) 31.16in (36.20in including castors)
105kg (231lbs) excluding Transit cover
Transit Cover
(2) Measured in free space at 1 metre with a tone burst signal
(4) Measured in half-space at 1 metre with a tone burst signal
77