CDD‐LIVE
Approvals
SAFETY
Environmental
Country of origin
EMC EMISSION
EMC IMMUNITY
FCC CFR47
ICES‐003:2012
This is a class A product. In a domestic environment this product may cause radio interferences in which case the user may be
required to take adequate measures.
Safety Rules
•
•
•
•
•
•
CDD‐LIVE User Guide V1.0
USER GUIDE
IEC60065:2002 + A1:2006
IP24 When factory supplied and with appropriate cowls, and used with IP rated mains
connectors
United Kingdom
EN55103‐1:2009 + A1:2012
EN55103‐2:2009
PART 15B‐2015
This CDD‐Live product must be powered exclusively by an earth connected mains socket in electrical
networks compliant to the IEC 364 or similar local rules. It is absolutely vital that the user verifies this
fundamental safety requirement. If you are in any doubt, get the installation checked by qualified
personnel before use
The means of disconnection from the mains is the mains plug. We strongly recommend that you power
the CDD‐Live by a professionally installed mains supply with an easily accessible on/off switch or circuit
breaker.
Before powering the CDD‐Live, via Neutrik© PowerCON TRUE1 connector, make sure that the unit is
supplied with the correct mains operating voltage: 100 ‐ 240V ~ 50 ‐ 60Hz
The CDD‐Live products are protected by internal fuses located on the main amplifier board Designated
F500
CDD‐Live 8
CDD‐Live 10/12
CDD‐Live 118
CDD‐Live 218
Do not use this unit if the electrical power cord is frayed or broken
Do not remove the cover. Removing the cover will expose you to potentially dangerous voltage
1 x T4AH 250V, 5 x 20mm
1 x T6.3AH 250V, 5 x 20mm
1 x T6.3AH 250V, 5 x 20mm
2 x T6.3AH 250V, 5 x 20mm
2