Personality Board - HP ProLiant SL250s Gen8 Maintenance And Service Manual

After you replace the system board, you must re-enter the server serial number and the product ID.
During the server startup sequence, press the F9 key to access RBSU.
1.
Select the Advanced Options menu.
2.
Select Service Options.
3.
Select Serial Number. The following warning appears:
4.
Warning: The serial number should ONLY be modified by qualified service
personnel. This value should always match the serial number located on the
chassis.
Press the Enter key to clear the warning.
5.
Enter the serial number and press the Enter key.
6.
Select Product ID. The following warning appears:
7.
Warning: The Product ID should ONLY be modified by qualified service
personnel. This value should always match the Product ID located on the
chassis.
Enter the product ID and press the Enter key.
8.
Press the Esc key to close the menu.
9.
Press the Esc key to exit RBSU.
10.
Press the F10 key to confirm exiting RBSU. The server automatically reboots.
11.

Personality board

To remove the component:
Power down the server (on page 24).
1.
Disconnect all peripheral cables from the server.
2.
Remove the server from the chassis (on page 24).
3.
Remove the front GPU cage (on page 26).
4.
Remove the interposer board assembly (on page 26).
5.
Remove the front GPU bracket (on page 27).
6.
Remove the level 2 power board
7.
Disconnect all cables connected to the personality board.
8.
("Level 2 power board" on page 33).
Removal and replacement procedures 58