Faults - Kärcher HDS 551 C Eco Instruction Manual

Clean sieve in water and reinstall.
Clean sieve in the water shortage safe
guard
Figure 7
Loosen covering nut and take off hose.
Figure 8
Take out sieve.
Note
If necessary turn in screw M8 appr. 5 mm in-
wards and therewith pull out sieve.
Clean sieve in water.
Push sieve inwards.
Put on hose.
Tighten covering nut firmly.
Clean filter at the detergent suck hose
Figure 9
Take out detergent suck hose.
Clean filter in water and reinstall.
Oil change.
Figure 10
Ready a catch bin for appr. 1 Liter oil.
Kärcher Hint: Use a sliced RM 110 bottle as
a catch gutter.
ready catch gutter.
loosen release screw.
Release oil over the catch gutter into the
catch bin.
Dispose of old oil ecologically or turn in at
a gathering point.
Tighten release screw.
Fill oil slowly up to the MAX marking.
Note
Air pockets must be able to leak out.
For oil type refer to technical specifica-
tions.

Faults

Indicator lamp fuel shortage glows
Only HDS 558.../601.../698.../798...
Figure 2 - Pos. 2
– Fuel tank empty
Refill.
Indicator lamp "Ready for use"
turns off
Figure 2 - Pos. 4
– Engine overload/overheat
Turn device switch on "0" and let engine
cool off for min. 5 minutes.
If malfunction still occurs, have device
checked by customer service.
Indicator lamp liquid softener glows
Only HDS 558.../601.../698.../798...
Figure 2 - Pos. 3
– Liquid softener tank is empty, due to
technical reasons a remainder stays in
the tank.
Refill.
– Electrodes in the tank are dirty
Clean the electrodes.
Indicator lamp for detergent glows
Only HDS 558.../601.../698.../798...
Figure 2 - Pos. 5
– Detergent tank is empty.
Refill.
33
English