GE TBI18JIBPRWW Use And Care & Installation Manual page 17

REVERSE HARDWARE ON CABINET
1
TRANSFER BOTTOM HINGE BRACKET TO THE LEFT.
a. Remove the base grille. Grasp it at the bottom
and pull it straight out.
Bottom right
b. Using a Torxdriver, remove the hinge bracket
and plastic washer from the bottom right side
of the cabinet.
Plastic washer
c. Reinstall the hinge bracket and plastic
washer to the bottom left side of the cabinet.
Plastic washer
Bottom left
2
TRANSFER CENTER HINGE BRACKET TO THE LEFT.
Do not remove this screw
Center right
a. Remove the center hinge bracket by removing
the three Torx screws. NOTE: Keep these
screws with the hinge bracket. They are
longer screws and will be used when
installing the hinge on the other side.
b. Remove the three Torx screws from the center
left side of the cabinet. Screw them into the holes
on the right side, which were uncovered in Step
(a) above.
Center left
Place the center hinge bracket over the holes at the
center left side of the cabinet, insert the three
screws that were removed with the center hinge
bracket in Step (a) and tighten them.
3
TRANSFER TOP HINGE TO THE LEFT.
Interchange hinge and screws at top right with
screws at top left of cabinet. Do not tighten
screws on hinge side at this time.
4
TRANSFER DOOR STOPS.
a. On each door, move the metal door stop from
the right end to the left end.
b. Move any screws from the left end to the
right end.
Do not remove this screw
(continued next page)
17