Danfoss MCD 200 Installation Instructions Manual page 5

MCD Modbus Module Instructions
1
For MCD 500 models MCD5-0068B and smaller this value will be 10 times greater than the value
displayed on the LCP.
2
See the relevant soft starter literature for a complete parameter list. The first product parameter
is always allocated to register 40009. The last product parameter is allocated to register 40XXX,
where XXX = 008 plus total number of available parameters in the product.
N.B.!:
The numbering of parameter options via serial communications differs slightly from the
numbering displayed on the LCP. Numbering via the Modbus Module starts at 0, so for
Par. 2-1 Phase Sequence, the options are 1~3 on the LCP but 0~2 via the module.
MG.17.F5.02 - VLT® is a registered Danfoss trademark
Modbus Register
5