Table of Contents
Advertisement
starts to vibrate abnormally
performing maintenance
The small blade fitted to the lawn guard
is designed to trim the new extended line
to the correct length for safe and optimum
performance. It is very sharp, do not touch
it particularly when cleaning the product.
Always ensure that ventilation openings
are kept clear of debris.
Make sure the cutting head attachment is
properly installed and securely fastened.
Make sure all guards, deflectors and
handles
are
properly
attached.
Do not modify the product in any way, this
may increase the risk of injury to yourself
or others.
Use only the manufacturer's replacement
cutting line. Do not use any other cutting
attachment.
Immediately switch off and disconnect from
the mains once in the event of accident
or breakdown. Don't operate the product
again until it's fully checked by authorised
service center.
TRANSPORTATION AND STORAGE
Stop the product and allow it to cool before
storing or transporting.
Clean all foreign material from the product.
Store it in a cool dry and well-ventilated
place that is inaccessible to children.
Keep away from corrosive agents such as
garden chemicals and de-icing salts. Do
not store outdoors.
For storage, always disconnect from power
supply and wind cable.
For transportation, secure the product
against movement or falling to prevent
injury to persons or damage to the product.
MAINTENANCE
WARNING
Use
only
original
replacement
parts,
attachments. Failure to do so can cause
possible injury, poor performance and may
void your warranty.
and
securely
manufacturer's
accessories
and
WARNING
Servicing
requires
knowledge and should be performed
service we suggest you return the product
to your nearest authorized service center for
repair. When servicing, use only identical
replacement parts.
Switch off and disconnect from the mains
before: conducting any maintenance or
cleaning work.
You may make adjustments and repairs
described here. For other repairs, contact
the authorized service agent.
For replacement line use only nylon
filament line of the diameter described in
the specification table of this manual
After extending new cutter line, always
return the product to its normal operating
position before starting.
After each use, clean the product with a
soft dry cloth. Any part that is damaged
should be properly repaired or replaced by
an authorized service centre.
Check all nuts, bolts and screws at frequent
intervals for proper tightness to ensure the
product is in safe working condition.
RESIDUAL RISKS
Even when the product is used as prescribed,
it is still impossible to completely eliminate
certain residual risk factors. The following
hazards may arise in use and the operator
should pay special attention to avoid the
following:
Injury caused by vibration. Hold the product
by designated handles and restrict working
time and exposure.
Exposure to noise can cause hearing injury.
Wear ear protection and limit exposure.
Eye injury due to flying debris. Wear eye
protection at all times.
RISK REDUCTION
It has been reported that vibrations from
hand-held products may contribute to a
condition called Raynaud's Syndrome in
certain individuals. Symptoms may include
tingling, numbness and blanching of the
extreme
care
and
3
Advertisement
Table of Contents
