Stelpro BF SERIES User Manual

WARNING
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOL-
LOWING:
1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.
2. Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power
from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards,
including fire-rated construction.
4. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment
to prevent back drafting. Follow the heating equipment manufacturer's guideline and safety standards such as those published
by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code authorities.
5. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application and be connected to a GFCI
(Ground Fault Circuit Interrupter) – protected branch circuit.
8. Ensure the ceiling thermal insulation where the unit is installed is less than R40. (For installation in Canada only.)
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-
STATE SPEED CONTROL DEVICE.
CAUTION:
1. For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapours.
2. If these instructions are not followed, the warranty will be considered null and void and the manufacturer deems no further
responsibility for this product.
3. If the installer or the user modifies the unit, he will be held responsible for any damage resulting from this modification.
4. For connexions, use only 15A at 120V certified switches.
5. This unit must be properly grounded.
6. Not for use in kitchen.
7. This unit should be installed at least 2.1 m (7 feet) above the floor level.
8. The product is not intended for connection to rigid metal conduit.
For further information or to consult this guide online, please visit our website at www.stelpro.com
USER'S GUIDE
BF SERIES
BATHROOM FANS
REPLACEMENT COMPONENT LIST INCLUDED
SAVE THESE INSTRUCTIONS

IMPORTANT INSTRUCTIONS

3
SERIES
INSBF1215