Disinfecting And Cleaning; Checking Points To Consider; Product Identification; Back Cover - PDi -E24LEDA Service Manual

Your Source for Healthcare and
™
Wellness Infotainment

Disinfecting and Cleaning

The E24LEDA should be disinfected before performing any service. The following procedure is only a recommendation.
Your hospital or company may have a different procedure to follow.
Caution: Before using any cleaning or disinfecting agent on the ELED units, perform a spot check by wetting a
small area of the cabinet. Verify the agent does not discolor or deteriorate the cabinet.
1. The ELED unit has been designed to withstand up to a 5% chlorine based disinfectant. Many alcohol and
ammonia based disinfectants have also been tested with success. Apply the cleaner or disinfectant per its
recommended instructions.
Note: Most disinfectants require a waiting time following application and prior to wipe-down.
2. The manufacturer recommends isopropyl alcohol for the cleaning of the LCD screen.

Checking Points to Consider

Dynamic picture adjustments to Brightness, Contrast, Color, and Tint are available using the IR Remote Control, Part
number PD108-420, using the SETUP/Picture menu.
1. Check the appearance of the replacement panel and circuit boards for both physical damage and part number
accuracy.
2. Check the model label. Verify model names and board model matches.
3. Check details of defective condition and history. Contact PDi with serial number for details.

Product Identification

Product Label
The E24 is easily identified using the product label located on the back cabinet housing.
Serial Number Format Explanation
1. The first two digits compose the year of manufacture. 2013 would be 13.
2. The second two digits compose the week of manufacture. 26 would be week 26.
3. The single alphabetic character represents the place of manufacturing.
4. The next three alphanumeric characters compose the unique model ID.
5. The next character is the revision level.
6. The next five digits compose the serial number starting with the first unit produced in the current year.

Back Cover

1. Remove (4) screws from the back cover.
2. Remove back cover starting at top of TV, being
careful not to break tabs and avoid connectors
on main board. Avoid putting strain on cables
connecting the front and rear pieces.
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664
MODEL NUMBER:
PDI-E24LEDA-NK LED TV
Service Manual
Document Number:
PD196-275R3
Page 6 of 12