Beurer monogram Instructions Manual

Beurer monogram Instructions Manual

Heated mattress cover/?heated underblanket.
Hide thumbs Also See for monogram:

Advertisement

Instructions
These instructions
are for the
Komfort heated
mattress cover /
heated under­
blanket.
06.0.43510
Hohenstein
Approved to European Safety Standard EN 60335-2-17
Important instructions
Please read these instructions carefully
before you use your heated underblanket,
and keep them for future use
1

Advertisement

Table of Contents
loading

Summary of Contents for Beurer monogram

  • Page 1 Instructions These instructions are for the Komfort heated mattress cover / heated under­ blanket. 06.0.43510 Hohenstein Approved to European Safety Standard EN 60335-2-17 Important instructions Please read these instructions carefully before you use your heated underblanket, and keep them for future use...
  • Page 2: Explanation Of Symbols

    Explanation of symbols Read instructions! Do not pierce with needles! Never use if folded, rucked or compressed! The textiles used for this device meet the stringent human ecological require- ments of Oeko Tex Standard 06.0.43510 Hohenstein 100, as verified by Hohenstein Research Institute.
  • Page 3: Items Included In The Package

    Introduction Please read these instructions carefully before you fit this heated underblanket to your bed. We have written the instructions so you can identify the correct fitting instructions for your heated underblanket. The heated underblanket has been designed to give you a choice of heat settings to warm up your bed, and the option to use it all night so your bed is nice and snug from the moment you get into it and stays cosy all night.
  • Page 4: Proper Use

    – only be operated with the switch indicated on the device (label) – not be switched on if it is folded, rucked or compressed – not be tucked into the bed or laid around the mattress – never be wedged (especially with adjustable beds or divided mattresses) –...
  • Page 5: Electrical Safety

    Safety Your heated underblanket has been designed and fully tested to the European Safety Standards. It has been certified by the Intertek Testing and Certification Ltd. UK and shows the safety mark “BEAB Approved”. Your heated underblanket is safe and can be used all night (setting “1”). An electronic sensor mechanism in your heated underblanket protects it from over- heating by switching it off automatically if it is faulty.
  • Page 6 Then secure your contour sheet as accustomed so that the heated underblanket is between your mattress and the contour sheet. Make sure that the heated underblanket is always spread out flat and does not push together or wrinkle during use. Check its position when making the bed. The heated underblanket may only be switched on when it is spread out flat. We recommend switching on the heated underblanket approx.
  • Page 7 Using your heated underblanket Your heated underblanket has a preheat facility for your bed which will allow you to change the heat setting of the heated underblanket when you get into bed. The heated underblanket is safe to use all night. All our heated underblankets have a choice of preheat settings 1 to 6, with 6 being the warmest.
  • Page 8: Routine Checks

    squeeze the soapy water out of the heated underblanket and rinse it thoroughly with fresh luke warm water, gently squeezing making sure you do not wring it. Machine washing Put the heated underblanket in a large pillow case, duvet cover or similar thin material, or a net bag, and then put it in the washing machine and wash on a wool programme at 30 °C. Use a mild detergent with dosage according to the manufac- turer’s instructions.
  • Page 9: Technical Data

    When you make the bed, check the controller cord is firmly connected to the heated underblanket. Check the cords and control unit regularly for wear or damage. If there is any, r eturn the heated underblanket and control unit immediately to our service address. The contact details are at end of this leaflet. If the supply cord, controller or connector is damaged, it must only be replaced by customer services.
  • Page 10 Tel. 0844 488 9100, Fax 0844 488 9101 Bytek Office Systems Limited, Unit 1a Damanstown Way, Dublin 15, Ireland, Tel. + 353 1 8135545, Fax + 353 1 8135520 Manufacturer: Beurer GmbH Soeflinger Strasse 218 89077 Ulm/Germany Website: www.beurer.com We have a policy of continuously improving product design an quality. We have...

Table of Contents